Standard DAT-15 with GPS tracking.

Assembling the DAT off the back of a Ute.

DAT-15 with 220cm Main Mast.

380W BlueSun Solar Panels.

The Panel Racking.

Lowering Assembled Racking onto the Mast.

Two DAT-15 units.

24V DC Anemometer (Wind Sensor).

Oversized Trenching.

Foundation Cages Made in Australia.

13

Letting Cement harden before Installation.

Setting up the Main Mast Level.

The Main Mast levied.

19

DAT-15 Spacing Brisbane Latitude.

DAT-15 Spacing Sydney Latitude.

DAT-15 Spacing Melbourne Latitude.

All Double Flanged Foundation Pole Holes, should have an additional 30cm depth, to provide a 30cm Cement Bed below the bottom Flange Plate !

Cemented block with Piles, Anchor Bars & Booka-rods set 20cm above Ground.

Piles with Booker-rods Welded to Anchor Plates.

Finished Foundation with only the Booka-rods above Cement.

For those looking to Dig or Auger there own Foundation holes;

• A DAt-15 Double Flanged Foundation Pole requires a minimum 60cm Diameter Foundation Hole.
• A Caged re-bar Foundation requires a 90cm Diameter Foundation Hole.

NB: It is important to allow an additional 30cm Hole depth, this provides a 30cm Cement Bed below the bottom Flange Plate to take the vertical load of the DAT.

We advisable to install a Earth/Ground spike at the same time, old school would be a Re-bar or Star Picket.